![DJI Mini 3 Pro [image]](https://www.onedrone.com/store/image/cache/catalog/banners/dji_mini_3_pro_no_rc_-550x550w-200x120w.jpg)
-150x150h.jpg)
-1000x1000-150x150.jpg)
-150x150.png)
Search Criteria
Products meeting the search criteria
Brand: Mauch Electronic
Model: MAU2-060
Power-Cube / Pixhawk 2.1 cable / 2x Clik-Mate-6P / L = 200mm
To connect Power-Cube output 1 to Pixhawk 2.1 Power 1 connector.
REM: This cable is standard delivery with any Power-Cube !..
6.90€
Ex Tax:5.66€
Brand: DJI
Model: DJI-X4-CARE
DJI Care Refresh is an effective, comprehensive warranty for DJI products, offering you greater peace of mind every time you fly. Click here.
Please Note:For a small additional charge, DJI Care Refresh offers up to two replacement units within one year. If you are purchasing DJI Care Refresh separat..
69.90€
Ex Tax:57.30€
Model: alexamp2
Silicon Soft Power cable for Alexa Mini - lenght 1m.
Original connector is D-tap, but we can install some other connector too...
108.90€
Ex Tax:89.26€
Brand: Galaxy GRS
Model: GA-TPA
Training pyro-actuator for Galaxy parachute.
you remove pyroactuator and put this electronic so you can check if everything is working...
67.90€
Ex Tax:55.66€
Model: DJI-P3-RC
Spare Phantom 3 - Remote Controller (Pro/Adv)..
316.90€
Ex Tax:259.75€
Model: DJI-M6-AAF
Located on both ends of the carbon tubes, used to tighten screws. Must be replaced when replacing airframe arms...
55.90€
Ex Tax:45.82€
Model: DJI-M6-CT
Matrice 600 Aircraft Arm Carbon Tube is applicable to all arms...
23.90€
Ex Tax:19.59€
Model: DJI-M6-LGL
Matrice 600 Landing Gear Leg (outer diameter 25mm)..
25.90€
Ex Tax:21.23€
Brand: Mauch Electronic
Model: MAU2-072
50A - Current measurement sensor board, based on Allegro Hall Sensor ACS-50U.
The voltage reading of the LiPo is optimised for up to 14S LiPo packs.
This Sensor board needs a power supply. So please select the matching BEC according your preference from the BEC section.
The BEC will also power th..
54.90€
Ex Tax:45.00€
Brand: Mauch Electronic
Model: MAU2-059
This switch connects to any Power-Cube "V3" or 030: 2x 200A PDB and acts like an manual power on/off control.
It isn"t just a "switch". There is a small PCB included into the main wire which implements an current control mode, rather than a simple on/off.
The switch has already an installed 3D print..
24.90€
Ex Tax:20.41€
Brand: Mauch Electronic
Model: MAU2-050
This cable connects a PL BEC to the Power 2 input on a Pixhawk 2.1.
Molex CLIK-Mate 2.0mm 6p / L = 150mm..
5.90€
Ex Tax:4.84€
