%20(1)-250x250w.jpg "DJI Avata 2 Pro-View Combo")
![DJI Mini 3 Pro [image]](https://www.onedrone.com/store/image/cache/catalog/banners/dji_mini_3_pro_no_rc_-550x550w-200x120w.jpg)
-150x150h.jpg)
-1000x1000-150x150.jpg)
-150x150.png)
Iskalni kriterij
Izdelki, ki se ujemajo s kriterijem iskanja
Model: 010-0153-00
This Waterproof Castle Creations CC BEC 2.0 is the power solution for cinelifters video system.
The latter will give you higher voltage ranges.
This voltage regulator is perfect for powering servos, cameras and other power-hungry accessories.
The CC BEC 2.0 is the solution to protect your electronic..
61.39€
Brez DDV:61.39€
Model: 010-0004-00
The CC BEC 10A from Castle Creations is a staple in RC and makes the perfect upgrade to the OEM equipment found in any plane.
It will be useful when high power servos are used, where the ESC does not have an internal BEC or where the existing BEC is not adequate.
This BEC is designed to operate with..
31.89€
Brez DDV:31.89€
Model: CANPDB-4A
This CANPDB from Matek will allow you to plug four CAN devices into one plug.
*Power and distance are subject to specific regulations, be sure to respect those established in the country where you are playing.
Specifications
6V to 55V Operating Input Range(2S-12S Li-xx)
5.2V output on “5V” p..
15.49€
Brez DDV:15.49€
Blagovna znamka: Flywoo
Model: FW19002409
Customise your quad to your liking with these LED strips included a 3.3V BEC.
Available in blue, pink, green, red and white.
Note : If the BEC input is a 6S battery, a 6S voltage capacitor needs to be added.
..
13.85€
Brez DDV:13.85€
Model: BEC-GOGGLES-G2V2
This SpeedyBee BEC is intended to power your DJI Goggles 2 and/or your DJI V2 goggles.
In addition to supporting DJI Goggles, the SpeedyBee Goggles BEC is also compatible with goggles having the same port (9.2V output).
..
17.13€
Brez DDV:17.13€
Model: 010-0154-00
The Castle Creations CC BEC 2.0 is the power solution for cinelifters video system.
The latter will give you higher voltage ranges.
This voltage regulator is perfect for powering servos, cameras and other power-hungry accessories.
The CC BEC 2.0 is the solution to protect your electronic components ..
50.74€
Brez DDV:50.74€
Blagovna znamka: Mauch Electronic
Model: MAU2-082
Input 2-6S LiPo / max. 28V.
Output 5.35V / 3A -> +/- 0.05V –> Ripple 10mV (0.2%) at 1.5A output current.
Input wrong polarity protection, as well as Panasonic FM input and output capacitors to prevent burn out of the UBEC from voltage spikes.
20cm output cable with Molex / 6p / Clik-Mate 2.0mm. (To ..
22.05€
Brez DDV:22.05€
Model: HM-SB
HiModel 6-50V Input 20A Large Current Switching Mode Voltage Regulator/ SBEC
HiModel 20A SBECInput: 6 - 50.4 VOutput voltage: 7.4V 8.4V 9V 12V OUTPUT (jumper selection)Current: 20amps continuous/ 25amps peak (2 seconds)Mode: Switch-modeQuiescent current: 60uA to 200uASize: 45 x 26 x 8mmWeight: 30g..
30.25€
Brez DDV:30.25€
Model: KW-BEC-6S
High Quality, small and light 5V/12V 3A UBEC Support 2-6S/3-6S Lipo Battery Fully Shielded Anti-interference Voltage Stabilizer in Alu housing
Move switch on the side, switch between two output voltages: 5V or 12V
Input voltage: 7-28V (2-6S)Current output: 3AOutput voltage: 5V/12V (switch)Operating ..
12.21€
Brez DDV:12.21€
Blagovna znamka: Gremsy
Model: GR-P-UBEC
A switching power supply that has dual outputs (12V-5A) and accept wide input range from 14V to 52V, comes in a small and lightweight module. This UBEC should be used with the PIXY where power for Flir Duo Pro R via the AUX 8-pin cable on the tilt cage. ..
67.13€
Brez DDV:67.13€
Model: HK-SB-12S
The all new Multistar twin output SBEC is an advanced switching DC-DC regulator designed specifically with multirotors in mind.It will simultaneously supply a constant 5Amps at 5V and 10Amps at 12V. It works with 2-13 cell lipoly packs and supplies an interference free constant 5V to your receiver a..
30.25€
Brez DDV:30.25€
Blagovna znamka: Mauch Electronic
Model: MAU2-025
Input 4-14S LiPo / max. 60V.
Output 2x 5.30V / 1x 5.0V / 1x 12.0V / 3A -> +/- 0.05V –> Ripple 1mV @ 1.5A output current.
Inclusive LDO power supply (+5.00V +/- 0.03V) for the sensor board PL-xxx as well as PL- Sensor Hub X2/X8 and output conector with Molex Clik-Mate 4p.
Blue power "ON" LED.
59mm x..
188.44€
Brez DDV:188.44€