AlexMos 32 BIT BGC Encoder System Set I

  • enc1
  • 8
  • 509.96€

  • Ex Tax: 418.00€
- OR -

ALEXMOS 32 BIT BGC WITH ENCODER SYSTEM COMBO SET 6KG

Descriptions:
Encoders are special sensors that are added to each brushless motor of a Gimbal Stabilizer allowing the system to more accurately track motor position for increased stability which in turn also increases battery efficiency.

What's encoder technology in brushless gimbal control system?
The 3 axis stabilization gimbal system that relies on both active motor driven components and passive inertial stabilization. Passive stabilization relies on the principles of inertia (tendency of an object to resist change in its motion) and requires that the camera is well-balanced in the Pan, Tilt, and Roll Axes. Active stabilization refers to the techniques of using sensors to measure the camera’s Pan, Tilt, and Roll movements and counteract those movements using motors attached to the 3 axes. 

The GBM81080 series motor by iPower Motors are the ultimate brushless gimbal motor for Red Epic / Large Cameras.This motor is designed for large scale multi-rotor platforms looking to lift Red Epic & DSLR sized gear – 6-7KG/cm Torque.


Features:
- Easy to do gimbal tuning,no need to do much calibration work any more.
- Power saving, 5 times long working time than gimbal without encoder system.
- Twin IMUs.
- Faster  response,motor torque increasing instantly,no bug for difficult rotating angle any more.
- Encoder chip A5048a


Package included:
- 3 x GBM8108-90T motor (encoders already mounted on the motors)
- 3 x AS5048A encoder chips with CNC alum cover
- 3 x Round magnets block
- 1 x Pre-flashed encoder firmware alexmos 32BIT BGC set

Connecting encoders to the regular SimpleBGC 32bit board

Write a review

Note: HTML is not translated!
    Bad           Good